LICENSED & INSURED · CCC1337211

Roof Repair in Stuart, FL

Leaks, storm damage, lifted shingles, cracked tile, failed flashing — found fast and fixed right the first time.

State LicensedFlorida CCC1337211
Fully InsuredLiability & workers' comp
4.8 RatedBy your neighbors
Res + CommercialHomes & businesses alike
Free EstimatesHonest & itemized

What Our Stuart Roof Repair Covers

Leak detection

We trace water back to the actual entry point instead of patching the stain on your ceiling.

Storm damage repair

Wind-lifted shingles, cracked tile, torn flashing, and impact damage — documented and repaired.

Flashing & penetrations

Pipe boots, valleys, chimneys, and skylights — where the large majority of leaks actually start.

Emergency tarping

Water coming in right now? We can get a tarp on it while the permanent repair is scheduled.

Included in Every Roof Repair Job

Leak detection and tracing to the real entry pointShingle, tile, and metal panel replacementFlashing, boot, and pipe-penetration repairValley and ridge repairSoffit, fascia, and drip-edge repairEmergency tarping after a storm

Where We Work in Stuart

We take calls across Stuart — including downtown Stuart, Sewall's Point, Port Salerno, Rocky Point, and the riverfront streets along the St. Lucie River. If you are not sure whether your address is in our area, call us; it almost certainly is.

What Roof Repair Costs in Stuart

Most repairs land in the low hundreds to a few thousand

A single boot or a handful of shingles is a small job. Widespread fastener failure, soft decking, or storm damage across multiple slopes is a different conversation — and sometimes replacement is genuinely the cheaper answer over five years. We will tell you which one you are looking at. See our Florida roof cost guide for 2026 pricing by material, or use the roof cost estimator.

How the Job Actually Goes

We come out and actually get on the roof — no drive-by estimates.

You get photos of what we found, including the parts you cannot see from the ground.

We give you an itemized written estimate and explain the options, including doing nothing.

Once you approve, we schedule the work and handle permitting and inspections.

We clean up completely, magnet-sweep for nails, and hand you the warranty and documentation.

Permits & code

Permitting and code in Stuart

Who issues the permit

Work in Stuart is permitted through the City of Stuart Building Department. The City of Stuart maintains its own building department and fee resolution, separate from Martin County. We pull it, schedule the inspections, and meet the inspector — none of that lands on you.

What the code actually requires

Martin County enforces the Florida Building Code and its ASCE 7-22 wind provisions. Martin is not an HVHZ county; only Miami-Dade and Broward are. What does bite here is timing — county plan review commonly runs about 10–21 days, so we submit early rather than promising you a start date we cannot hold. Repairs still get pulled and inspected when the work is structural or covers enough area — we do not skip that step to save you a fee.

What we see on Stuart roofs

Downtown Stuart and Sewall’s Point cover everything from historic frame to modern waterfront construction.

Wind mitigation, while we are up there

A re-roof is the cheapest moment you will ever get to earn wind mitigation credits, because the nailing pattern and secondary water barrier are going in anyway. We document it so your insurer can actually apply the discount. How wind mitigation credits work →

Stuart Roof Repair FAQs

Do you actually work in Stuart?

We work Stuart and Martin County directly. Our shop is in Sebastian, and Stuart is a normal service day for our crews — not a special trip.

How fast can you get someone out to look at the roof?

For active leaks and storm damage we prioritize same-week and often next-day. For planned work, we usually have an estimator out within a day or two.

Do you pull the permit and handle inspections?

Yes. We pull the permit through the City of Stuart Building Department (or Martin County Building Division for unincorporated addresses), schedule the required inspections, and give you the closed-permit documentation at the end.

Will you repair a roof instead of pushing a replacement?

Yes, and we do it regularly. If your roof has years left, we will say so and tell you what to watch. A repair we talk you out of today is a replacement we earn honestly later.

Do you help with insurance claims?

We do. We document damage properly with dated photos and measurements so your adjuster has what they need. We are roofers, not public adjusters — but good documentation is most of the battle.

Get a Free Roof Repair Estimate in Stuart, FL

Call Leeward Roofing at 772-589-2400 or send us the details below. We inspect first, then quote — no pressure, no games.

24/7 Storm Response

Martin County storm damage? Don't let the second rain in.

Stuart, Palm City, Jensen Beach and Hobe Sound all take direct coastal wind, and Martin County plan review is not instant — so getting the damage documented early matters as much as the tarp itself.

After a storm — do this
  1. Stay off the roof. Assess from the ground and from inside the attic.
  2. Photograph everything — wide shots and close-ups — before any cleanup.
  3. Call for emergency tarping to stop water getting further in.
  4. Verify any contractor's Florida licence before you sign anything.
Our work

Recent Leeward jobs

Real Treasure Coast roofs installed by our own crews — not stock photography.

Ridge and hip detail - Leeward Roofing, Treasure Coast FL
Ridge and hip detail
Replacement day, in-house crew - Leeward Roofing, Treasure Coast FL
Replacement day, in-house crew
Tracing a leak to its real source - Leeward Roofing, Treasure Coast FL
Tracing a leak to its real source

See the full project gallery →

Local reality

Stuart repairs: old roofs, high wind, hard water access

Martin County runs the highest design wind speeds we work to, and Stuart has the most cut-up older roofs in the region.

The transitions are where the leaks are

Downtown Stuart, Krueger Creek and the older riverfront neighbourhoods carry 1950s–1970s homes that have been added onto repeatedly. Every addition creates a roof-to-wall junction or a low-slope-to-steep transition, and those are where water gets in — essentially always. Repairing at the ceiling stain almost never works here because the entry point is uphill of it. We trace it from the attic first.

City of Stuart or Martin County

Inside the city limit, the City of Stuart Building Department. Palm City, Rio, Port Salerno, Hobe Sound and Jensen Beach go to Martin County. Two separate authorities with separate queues, so confirming the parcel before quoting is not a formality.

The highest wind speeds in our service area

Martin County generally runs 165–175 mph ultimate design wind speed, against 160 east of I-95 in Indian River County. Every fastener, edge metal gauge and product approval on a Stuart repair is selected against that figure. Metal cap nails for underlayment attachment are mandatory by a wide margin.

Sewall’s Point and the exposed waterfront are Exposure D

Open water upwind for 5,000 feet, or within 600 feet of it, under FBC R301.2.1.4.3. Stack Exposure D on Martin County wind speeds and the corner and perimeter pressures are the most demanding we work to. Out there we inspect the hardware before the covering, because salt takes the fasteners, drip edge, valley metal and vent hoods long before the shingles or tile wear out.

Permits on repairs

Florida’s HB 803 exemption for single-family work under $7,500 took effect 1 July 2026 but excludes structural work and any property partly or wholly in a flood hazard area — which captures most of the Stuart waterfront and all of Hutchinson Island. It also bars splitting a job to get under the threshold. We tell you honestly whether yours qualifies.

Narrow lots and difficult access

Riverfront Stuart has some of the tightest sites we work. Material staging, dumpster placement and crew access genuinely affect the number, and a bid that has not seen the property has not accounted for it.

Straight pricing

What a Stuart repair costs

At the top of our regional range, and the reasons are code and access rather than opportunism.

Most single-issue repairs in the Stuart area land between $500 and $3,000. The older cut-up downtown roofs and the Exposure D waterfront sit at the upper end.

Pipe boot replacement — $325 to $700 each

UV plus salt finishes rubber boots faster on the waterfront than inland. If one has failed the others are the same age.

Flashing rebuild — $750 to $2,600

The signature Stuart repair. New step and counterflashing woven into the courses on the roof-to-wall and addition transitions that cause most leaks here. Genuinely intricate work on a 1950s home with three additions.

Shingle repair — $475 to $1,250

Wind-lifted, creased or missing shingles plus resealing the field.

Valley repair — $950 to $3,000

New valley metal and courses either side, usually with decking. The older stock has valleys that have been leaking a while.

Tile repair — $550 to $2,900

Sewall’s Point, Martin Downs and the golf communities. Profile matching on 1980s and 1990s tile is the wildcard and we say so before starting.

Corroded metal replacement, waterfront

Drip edge, valley metal and vent hoods in corrosion-resistant spec. On Sewall’s Point this is frequently the actual repair.

Emergency tarping — $450 to $1,300

To stop active water while a claim is opened. See emergency roof tarping.

Book a free Stuart roof inspection → or call 772-589-2400.

Stuart roof repair FAQs

Who issues my roofing permit in Stuart?

Inside Stuart city limits, the City of Stuart Building Department. Palm City, Rio, Port Salerno, Hobe Sound and Jensen Beach addresses go to Martin County. They are separate authorities with separate submittal packets and inspection queues, so we confirm which owns your parcel before quoting.

My roof has leaked in the same place three times. Why do the repairs fail?

Because the repair was almost certainly made where the stain is rather than where the water enters. Water runs - a ceiling stain marks where it gave up, not where it got in. On older Stuart homes with multiple additions the entry point is nearly always a roof-to-wall or low-slope-to-steep transition uphill of the visible damage. We trace it from the attic before touching the roof.

What does a roof repair cost in Stuart?

Most single-issue repairs land between $500 and $3,000. Pipe boots run roughly $325 to $700 each, flashing rebuilds $750 to $2,600, shingle repair $475 to $1,250, valley repair $950 to $3,000 and tile repair $550 to $2,900. Waterfront and cut-up older roofs sit at the upper end.

Why are Stuart repairs more expensive than Port St. Lucie?

Three reasons, all real. Martin County runs the highest design wind speeds in our service area at roughly 165 to 175 mph, which dictates fastening and materials. Sewall’s Point and the exposed waterfront fall in Exposure D, requiring corrosion-resistant hardware throughout. And the older downtown housing has genuinely complex roof geometry on tight sites with difficult access.

Do I need a permit for a repair?

Often yes. The HB 803 exemption for single-family work under $7,500 took effect 1 July 2026 but excludes structural work and any property partly or wholly in a flood hazard area - which covers most of the Stuart waterfront and all of Hutchinson Island. It also prohibits splitting a job to get under the threshold.

My shingles look fine but it leaks. What is wrong?

On the waterfront it is usually the metal - fasteners, drip edge, valley metal or vent hoods corroding while the covering still looks serviceable. Inland it is most often a cracked pipe boot or a failed flashing at an addition transition.

What is Exposure D and does it apply to me?

It applies where open water prevails upwind for 5,000 feet, or within 600 feet of that condition - so Sewall’s Point, Hutchinson Island and much of the exposed waterfront. Combined with Martin County wind speeds it produces the highest corner and perimeter design pressures we work to, which changes fastener type, spacing and edge metal.

How fast can you get to Stuart?

Roughly an hour from our Sebastian shop down I-95, and a regular route. Active leaks are prioritised and we can usually inspect within 24 hours and tarp on the same visit.

Should I repair or replace?

If damage is localised, the roof is under roughly 12 to 15 years, the decking is sound and the affected area is comfortably under 25 per cent, repair is the right answer. Repeated leaks in unrelated spots or a roof past 20 is a different conversation. See roof replacement in Stuart.

Will insurance cover this?

Only sudden accidental damage such as a named storm, hail or impact - not age or wear. Many repairs also fall below the hurricane deductible, which is a percentage of dwelling coverage rather than a flat amount. See our insurance claim guide.

Nearby

We also work near Stuart

Same crews, same trucks — these are the communities immediately around Stuart that we cover from the Sebastian shop.

Not sure if you’re in our area? Ask us →

Let's take a look at your roof. Free.

No pressure, no obligation, and an honest answer even when that answer is "you don't need a new roof yet."

  • Free, itemized estimate in writing
  • Most inspections scheduled within 24 hours
  • We handle permits and insurance paperwork
  • Licensed CCC1337211 and fully insured
9577 Gator Drive, Unit #5, Sebastian, FL 32958
info@leewardroofing.com

Request your free estimate

Four quick fields. That's all we need.

Contact Form

Your info stays with us. No spam, ever.
Scroll to Top